MKS GEN-L V1.0 Makerbase / Placa Controladora de Impressora 3D

Descrição do Produto

Arduino MEGA compatible Atmega2560 and FT232 processors are compatible with all RAMPS class firmware
Firmware can use the same configuration as ramps1.4
Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board
Easy connect MKS TFT on AUX-1
All extra pins broken out the same as ramps1.4(AUX-1,AUX-2,AUX-3,Servos1)
3 x temperature ADC connectors for thermistors
Up to 5 motor driver with easy micro stepping setup (micro switches)
4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed,Extruder0,Extruder1, Fans)
4 layers PCB, optimize heat dissipation.
3 x 5V output, 3 x 12V-24V output interface.
6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
Recoverable fuse for short-circuit protection.
Package Contents:

MKS Gen-L v2.0 circuit board
jumpers

Informação Adicional